Universal 5D Shark Fin Antenna Auto Car Radio Aerials FM AM Stronger Signal Piano Paint For Toyota Yaris Vios Avensis

5D Shark fin antenna

By DA

Features and specifications:

5D shark fin antenna made from ABS plastic. It is coated in piano paint and comes in 14 colors. Features a 3M adhesive for a strong hold.

Note:

The shark bottom hole measures 12.3 x 5.7 cm. Please make sure your antenna base is smaller than that to ensure fit. If your antenna base is larger, please order the super shark as it can fit a larger base.

Colors

Showcase

Dimensions

Shark fin: length 21.3 cm (8.4 inch), width: 8.2 cm (3.2 inch), height: 6.8 cm (2.7 inch)

Bottom hole: length: 12.3 cm (4.8 inch), width: 5.7 cm (2.2 inch)

PET-L antenna cable for a stronger signal.

Piano paint/Plating/Carbon, ABS plastic

Bright surface, non-fading, durable ABS plastic

Package includes

1 Shark fin antenna

1 PET-L antenna cable

1 3M adhesive

1 pair copper screw and nut

Easy to install

① Stick the 3M adhesive onto the bottom of the shark fin.

② Remove the original antenna.

③ Tighten screw and nut on the original antenna base.

④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.

FAQ:

Question 1:The shark same color with the original car color?

Answer 1:The shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,hope you understand that.

Question 2:How about the radio signal effect after installation?

Answer 2:This antenna using purification copper fittings,through our tested,the signal close original antenna.

Question 3:The shark installed on the roof have little gap, is appropriate?

Answer 3:The shark bottom is little curve,most of models no have gap,few car  may be have a little gap,it does not affect the use.You can use more adhesive in to the gap.

Question 4:What should be note when installing?

Answer 4:Clean around antenna base,be sure without water or dust,first connect the cable and base,test the radio,if it is ok,than installing,heating 3M adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpressing 3 minutes after pasted,keep dry in 2 days.