


CC/CV 5A Lithium Charger Board XL4015 Adjustable 6-38V To 1.25-36V DC Step Down Power Supply Buck Module
17.4$
10.62$
Quantity:
1
Availability:
Out of StockDelivery estimate
Delivery:
Module highlights:
1.High power, high efficiency, 5A, low ripple;
2.Three in one:
(1) Used as an ordinary step-down module with over-current protection capability;
(2) Used as various voltage values of lithium batteries, batteries, nickel-cadmium nickel-metal hydride batteries (battery packs) chargers for solar panels, wind turbines and other occasions;
(3) Used as a high-power LED constant current driver module;
3. With constant voltage and constant current two modes, there are indicators to show which mode the module is currently in;
4. As a lithium battery charger, you can set the float voltage and charging current size, with an indicator to show whether it is charging or already full; (4) as a high-power LED constant current driver module; (5) as a high-power LED constant current driver module
Indicates whether it is charging or full;
5. With current limit protection function, even if the output is short-circuited, it will not burn the module.
Module parameters:
Input voltage:4-38V
Output voltage: 1.25-36V continuously adjustable
Output current: adjustable, large 5A
Output power: large 75W
Operating temperature: -40~+85 degrees
Operating frequency: 180KHz
Conversion efficiency: 96 hundred
Short circuit protection: Yes (limit current 8A)
Over-temperature protection: Yes (automatically shut down the output after over-temperature)
Input reverse protection: no, (if necessary, please string in the input high current diode)
Installation: four 3mm dowels
Wiring: terminal or welding terminal, V-IN is input, V-OUT is output.
Module size: length 61.7mm width 26.2mm height 15mm
Weight: 25g
Scope of application:
1. Use as a common step-down module with overcurrent protection capability
Usage method:
(1) Adjust the constant voltage potentiometer so that the output voltage reaches the voltage value you want.
(2) Measure the output short-circuit current with a multimeter at 10A (directly connect the two pens to the output terminal), and adjust the constant-current potentiometer so that the output current reaches the predetermined overcurrent protection value. (For example, the multimeter shows the current value is 4A, then you use the module when the high current can only be up to 4A, the current to 4A when the red constant voltage and constant current indicator is on, otherwise the indicator is off)
Note: When used in this state, due to the 0.05 ohm current sampling resistor on the output side, there will be a voltage drop of 0~0.3V after connecting the load, which is normal! This voltage drop is not pulled down by your load, but to the sampling resistor.
2. Use as a battery charger:
Modules without constant current function can not be used to charge the battery, due to the high voltage difference between the depleted battery and the charger, resulting in excessive charging current, resulting in damage to the battery, so the beginning of the constant current charging should be used on the battery, when the charging reaches a certain level, automatically switch back to constant voltage charging.
Usage:
(1) Determine the float voltage and charging current of the battery you need to charge; (if the lithium battery parameters for 3.7V/2200mAh, then the float voltage is 4.2V, large charging current 1C, that is, 2200mA)
(2) no-load conditions, the multimeter to measure the output voltage, adjust the constant voltage potentiometer so that the output voltage to reach the float voltage; (if the 3.7V lithium battery charging, the output voltage to 4.2V can be)
(3) Measure the output short-circuit current with a multimeter at 10A (directly connect the two pens to the output terminal), and adjust the constant-current potentiometer so that the output current reaches the predetermined charging current value;
(4) charging turn lamp current default factory for 0.1 times the charging current; (battery in the charging process current is gradually reduced, gradually from constant current charging to constant voltage charging, if the charging current is set to 1A, then when the charging current is less than 0.1A, the blue light is off, the green light is on, at this time, the battery charging is complete)
(5) Connect the battery, charging.
(Steps 1, 2, 3, 4 for: the input side of the power supply, the output side of the no-load not connected to the battery)
3. Used as a high-power LED constant current driver module:
(1) Determine the working current and working voltage you need to drive the LED;
(2) Under no-load conditions, measure the output voltage with a multimeter and adjust the constant voltage potentiometer so that the output voltage reaches the LED operating voltage;
(3) Measure the output short-circuit current with the multimeter 10A current gear, and at the same time adjust the constant current potentiometer to make the output current reach the predetermined LED working current;
(4) Connect the LED, test machine.
(Steps 1, 2, 3 for: input connected to the power supply, the output no-load not connected to the LEDs.)
Note: This module in more than 3A, 35W use, please strengthen the heat dissipation!!!!


Specifications
- Origin
- Mainland China
- EU LVD Voltage
- Low voltage: Below 50Vac or 75Vdc
- Choice
- yes
Customer Reviews
153 ratings
fast delivery (7)
satisfactory (7)
highly recommended (6)
excellent quality (4)
matches description (4)
quick delivery (3)
Customer photos (26)
S***v
January 3, 2026
delivery two weeks corresponds to the description
D***x
November 18, 2025
As described. Fine.
Buyer from Brazil
June 19, 2026
With only 1.88 amperes, the IC got very hot. poor product.
Buyer from France
April 24, 2026
Received quickly, works correctly, does not support 5A, heats up a lot, 2.5A is perfect.
Buyer from Ukraine
April 15, 2026
my favorite module that I use for making chargers for lithium-ion battery assemblies
D***r
March 4, 2026
OK
CC/CV 5A Lithium Charger Board XL4015 Adjustable 6-38V To 1.25-36V DC Step Down Power Supply Buck Module
17.4$
10.62$
Quantity:
1
Availability:
Out of StockDelivery estimate
Delivery:







