Antec P360 All-in-One CPU Liquid Cooler ARGB PWM Fan Water Cooling Heatsink Support LGA1700 LGA115x AMD Gaming PC Radiator

Antec P360 All-in-One CPU Liquid Cooler ARGB PWM Fan Water Cooling Heatsink Support LGA1700 LGA115x AMD Gaming PC Radiator

Important Installation Tips

1.Wiring Guide

①Pump cable (3‑Pin / 4‑Pin)

Prioritize the motherboard AIO_PUMP / PUMP_FAN header. This header runs at full speed by default for stable pump operation.

If no dedicated pump header is available, use SYS_FAN. Do NOT use CPU_FAN, which is reserved for radiator fans for speed adjustment.

②Radiator fan cables (4‑Pin PWM)

Connect to motherboard CPU_FAN header. Fans will auto‑adjust speed according to CPU temperature for balanced cooling and low noise.

For 240 / 360 AIO with multiple fans, use the included fan hub to combine fans into one cable before plugging into CPU_FAN.

③5V 3‑Pin ARGB (Addressable RGB)

Plug into motherboard 5V ARGB / ADD_GEN / WS2812B 3‑pin header.

⚠️ Do NOT connect to 12V RGB header, this will destroy ARGB lighting.

2.Fan Airflow Direction: Make sure fans blow air OUT of the case. Installing fans backwards will reduce cooling performance.

3.Screw Selection: Please use the correct matching screws. Do NOT mix up different‑length screws, to avoid damaging the radiator or motherboard.

4.AIO Tube Warning: Do not twist, kink or squeeze the water‑cooling tubes. Keep tubes free of sharp bends.

5.Tightening Note: Tighten mounting screws evenly in cross‑pattern. Do NOT over‑tighten, to prevent CPU damage.

6.AMD Note: This bracket supports AM4 / AM5 platforms. Double‑check bracket orientation before installation.

7.Remove protective film from cold‑head metal base before installation. Failure to remove will cause zero heat dissipation and overheating.

Product parameters

Supported platforms: Intel: LGA 1200/115X/1700 AMD: AM4/AM5

main body

Size: 360 * 120 * 25mm

Type: PWM ARGB LED fan

Speed: 800-1800 RPM ± 10%

Maximum air volume: 72 CFM max

Noise: 32.0 dB (A) max

Wind pressure: 2.2 mm H'o max

Lifespan: Room temperature 25 ℃, relative humidity 15-65%, can be used for 40000 hours

Connector: Fan: 4pin/ARGB: 3PIN

Water cooled exhaust

Size: 393 * 120 * 20mm

Material: Aluminum, polycarbonate

water pump

Size: 57 * 72 * 48mm

Connector: 4pin power supply

Lift: 1.2m

Flow rate: 1.3L/min

Lifespan: Room temperature of 25 ° C, relative humidity of 15-65%, can be used for 70000 hours

Noise: ≤ 27 dB (A)

water pipe

Size: 8 * 10 * 450mm