A98I-Accessory For Eufy L60 Replacement Parts For Eufy Clean L60 Main Brush Filters Dust Bags

Applicable models: for Eufy L60 / L50 / L60 SES / L50 SES / L60 Hybrid / L50 Hybrid robot vacuum cleaners Quick cleaning: The long strip design of the main brush allows the main brush to clean most of the ground garbage in a short time, improving the cleaning efficiency of the robot Edge cleaning: The side brushes are located on both sides of the robot, and the long bristles can penetrate into the corners and corners of the room to out garbage Efficient filtration: The filter can filter dust, hair, dandruff impurities in the air, and prevent particles from entering the motor and causing damage to the motor Dust collection: The garbage collected by the sweeper is sent to the dust bag, and it is replaced once it is full, which not only optimizes the garbage disposal method, but also prevents secondary pollution. Main brush cover: The main brush cover can reduce the possibility of hair entanglement during cleaning, ensuring that the main roller brush can work efficiently Features: 1. The V-shaped bristles of the main brush can penetrate deep into the gaps in the floor when turning, and can also gather the collected dust 2. If the filter is dirty, it can be cleaned with clean water and can be used again after being completely dried without affecting performance 3. There is a lifting seal plate on the dust bag card, which can be lifted when replacing accessories to prevent garbage from leaking out 4. The screwdriver in the set can assist in the installation of the side brush, and the cleaning brush can brush away the dust of the accessories and cut off the tangled hair Color: As Shown Material: plastic Package Contents: 1 x Rolling Brush 4 x Filter 4 x Dust Bag 4 x Side Brush 1 x Cover 1 x Cleaning Brush 1 x Screwdriver Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.