Cutting Discs for Dremel Rotary Tool, 3 Different Saw Blades ,Cutting Wood/Metal/Plastic/Glass/Stone and Make DIY Craft

ULTRA-FINE QUALITY, UNBEATABLE PRICE

1. With 6 HSS Circular Saw Blades, 10 Diamond Cutting Discs, 10 Resin Cutting Discs, 6 Mandrels and even 1 clear storage case,

2. This rotary cutting wheels set covers all the bases with quality products at a price any operator can afford.

3. Ideal for cutting, grooving trimming wood,plastic,ceramics,metal and DIY production.

6 pcs HSS CIRCULAR SAW BLADES –

The cut off saw blades are high speed steel and there are 6 kinds of outer diameters 22/25/32/35/44/50mm and the thickness of 0.8 mm. They are suitable for cutting wood, plastic products, aluminum alloy, soft metal, etc. And comes with 1pcs 1/8''(3.2mm) shank+ 1pcs 6mm shank.

10 pcs DIAMOND CUTTING WHEELS –

It is completely coated with fine diamond particles--thin and sharp. Designed for rotary tools and replacement EZ545/544 lock cut off wheel. Suitable for cutting gem, jade and glass.

10 pcs RESIN CUT OFF DISCS –

With low heat generation and thin cutting line, the cut off wheels are applicable to electric drills, hanging grinders, electric grinders, etc. They can be used to cut metal, plastic, chassis modification, thin metal circuit board and DIY production after connected with mandrels, and are ideal for olive cutting. And comes with 2pcs 3mm mandrels.

EASY TO INSTALL AND USE

These cutting wheels set for rotary tool are easy to install and replace. A small tip: The HSS cutting wheels should be cleaned with cloth after each use and wiped with machine oil when it is not used.

Dry and Wet Dual-use

Dripping water when cutting can lowering the temperature around the wood cutting wheel to ensure a long service life.

Remember the safe operation is the first. Please take good protection measures.

Before installing the spindle, check whether the machine is running normally, whether it is cracked or deformed.

Please use the Spanner to tighten when using and DO NOT tighten the chuck too strong to lock the spindle.

Please note that the mandrels must be fully inserted, otherwise it will be crooked by the High-speed rotation eccentricity

At the same time, as far as possible use small diameter saw blade and low speed under the situation of meeting the usage requirements. Speed must not exceed 20,000 rpm.

In the selection of saw blade, the smaller your electric mill, choosing a smaller saw blade will be much stabler.