DIFANG 7500mAH UPS Battery Power Adapter For Camera Waterproof Battery Backup UPS IP Camera Source Router WiFi Camera Charger

7500mAH (Factory Supply) DC12v 1.5A

UPS Uninterruptible Power Supply

lt can ensure that your camera can work normally
for 3-6 hours in the event of a power outage,
ensuring the safety of your property

Compatible with a variety of equipment.Widely used in audio, surveillance camera, mobile hard disk, radio, repeater and so on.

About battery installation

This UPS power supply INCLUDE batteries.

DC12V Battery Power Adapter Output 12V 1.5A UPS Monitoring Power Outage Endurance Power Supply WithBattery Security Monitoring

Function
*12V 1.5A surveillance camera UPS power supply
*It can supply power directly to the camera
*It can store power in the built-in battery
*Charging and powering can be done simultaneously
*Automatically use the built-in battery to power the camera when there is a power failure
*Compatible with 18650 batteries, please carefully read the installation instructions. It is recommended that each battery has a capacity between 1000mAh and 2000mA
*Suitable for most IP cameras on the market
*Good water resistance, can be used outdoors
Caution:
12V 2A power connector is 5.5mm to 2.1mm
Total output current of the two 12V output ports is 2A
Product parameters
Rated input voltage: AC176-264V
Rated frequency: 50/60Hz
Output port: AC plug
No-load pressure: 12.3-12.6V
Maximum peak current: 2.0A
Rated output voltage: voltage ± 12V-DC
Output port: AC
Rated working current: 1.6A
Working temperature: 70 ℃~- 20 ℃,full load, normal operation.
Storage temperature: - 20 ℃ to 85 ℃, with shell.
Operating humidity: 5% (0℃)~90% (40℃) full load, normal operation

Product parameters labeled as 121V1.5A, which is the lowest output parameters, the adapter can support the maximum output voltage of 12V2A, please note before ordering!

Charging and discharging at the same time
UPS power supply can be the same as the ordinary power supply for the camera to power, but also for the built-in battery to charge, wait until the power failure, the built-in battery can continue to power the camera, so that the camera continues to work,UPS with two outputs, please note: the total output current of the two output connectors is 2A.
Built-in battery for power supply(not included)
When the power is disconnected, the built-in battery(not included) can be powered to keep your camera working for up to 24 hours, so don't let the bad guys have a chance to take advantage of it!
Better than ordinary power supply
The UPS has a battery(not included), and there is no need to operate to switch the power supply, it continues to work after a power failure, and automatically switches to charging after power is applied, no complicated operation is needed.
Compatible with 18650 batteries (flat head)
You can install a rechargeable flat 18650 battery according to your own needs for use
Suitable for most IP cameras and surveillance
Suitable power supply line
12V 2A UPS power supply parameters