Sovol Filament Dryer 2023, SH01 Filament Dehydrator 3D Printer Spool Holder with Upgraded Fan, Dry Box for Keeping Filament Dry

About this item

【Remove Excess Moisture】3D printer filaments are hygroscopic, moisture would cause printing failure. Sovol SH01, a great addition to 3d printer, can remove excess moisture, keep your filament dry and bring you better prints. The surface of prints will be smoother, the layer adhesion increased. No more brittle PLA, PETG, ABS filament.

【Real-time Monitoring of Temp and Humidity inside】Displays the humidity and temperature in the dry box in real time. Setting temperature 40 °, 45 °, 50 ° C and setting time from 6 hours to 12 hours. If you use SH01 in a room with room temperature under 16℃, the temperature in the dryer box would not come up to 50℃. But do not worry, this would not decrease drying effect.

【Excellent Power-off Drying Mode】Silicone & PTFE seal makes it possible to store filaments for a long time without power and protects your filaments from moisture and dirt. You can put 4 bags of desiccants (not included in the package) inside the dryer box to improve drying efficience & quality.

【Large Capacity】 Sovol dryer box can store 2 filament rolls with a width of less than 70 mm or 1 filament roll with a width of less than 150 mm. Please open the PTFE seals on the top of the box during heating for Moisture evaporation.

【Heating More Evenly】 The unique design of the built-in fan in the box is based on the principle of modynamics of air, makes the filament heated more evenly. SH01 makes drying more efficient. Any questions about the product please feel free to contact us. Our technical support team will provide service as soon as we can.

Product Description

：

Evenly distributed heating ports.

Enough space for 2 rolls filament.

Built-in fan makes heating more evenly.

Two locking clips can lock the lid very tight and won't pop up the lip.

Please open the PTFE plugs on the top of the box during heating for Moisture evaporation.

Please put the filament rolls inside in this way to make the filament goes out more smoothly.