For XDJ-RX3 RR RX RX2 XZ All-in-One DJ Controller Driver Film Full Enclosure Protection

Description: This product sold in our store is a color film suitable for XDJ.
--The film is a customized product, and it is impossible to have no details and defects at all. It can only be perfectly customized to meet the protection equipment. All kinds of colors are available in stock! When fitting, it must be covered flat. Clean the surface dust of the machine before sticking, do not leave air, do not leave space, otherwise the air will be left to arch or pick up the package, because the film is the same as transparent glue, and a similar situation will not occur after sticking. In addition, please note. If the machine is installed in the DJ equipment bag. It is often worn and the edge will be warped. Please find the transparent glue around the seal in time to ensure that the film is complete! If you don't understand or don't understand how to take a hat and install a hat during the film process, please contact our customer service in time, and a reference tutorial will be sent to you! In addition, after XDJRX3, the impact pad will be cancelled, because of the type of soft rubber, it will fall off after a few days of sticking, and it cannot stick firmly. XDJXZ had it before, but it is not recommended to stick it. If you don't like it, it is not recommended to place an order to buy it! Please mark the overseas platforms sent abroad! Domestic sales are very small, but there are many overseas sales. Please check the color and model before placing an order!
-- Film method:
Remove all EQ caps, fader caps, effect selection caps, etc., and then clean the surface dust of the XDJ-RX3 machine. After removing the excess hole film, align the corner hole angle and stick it on the surface of the machine, and finally put it back into the hat!

Feature 1: The film is introduced using real imported PC materials, with a thickness of only 0.38 mm. In order to ensure that the EO cap and fader cap are not affected by the operation after being attached to the machine, the film is drawn according to the actual measurement of the machine, and then the bottom layer is printed, the knife mold is produced, and then the post-correction is made. There is no room for sloppiness.

Feature 2: Display after film fitting
The details are taken care of in place, and the knob caps are fitted with carefully selected materials. The fader caps are completely unaffected, the holes are cut and positioned, and the split fitting is simple and convenient.