Night Lamp With Motion Sensor Rechargeable LED USB Night Light Wireless Led Bedside Table Lamp Portable Camping Lighting

When charging the lamp, please use the original charging cable. The red light on means charging is in progress, the green light on means charging is complete.

1、Please fully charge the battery before using it for the first time, otherwise the light may not be use because of the
circuit protection.（The protection is automatically released after charging）
2、Do not use the light under high temperature and humidity; This product is not suitable for outdoor.
3、The light source and battery of the product are irreplaceable. After a long time of use, when the brightness of the product is very low under full power state or the power usage duration becomes shorter under normal usage, the whole lamp shall be replaced.


About this product

【Has Multiple Modes】: The motion sensor night light has three modes, namely normally open mode, induction mode and normally closed mode. Closet light with sensor can adjust the brightness of the light by long pressing the power button in always-on mode,you can switch by pressing the power button.There are three levels in total. They are 30%, 60% and 100% respectively.

【Lifespan】: The capacity of our night light has 14 LED lights. When the motion sensor closet light is in continuous lighting state, the lifespan is 6 to 8 hours (depending on the brightness of the light). If it is in induction mode, it can keep lighting for 2 to 3 months (activated 5 to 10 times a day in induction mode).

【AUTOMATIC MOTION SENSORS】: The detection distance of the night light with sensor is 3-5 m, and the detection angle is 120 degrees. It will automatically turn on when within its range and automatically turn off after 15 to 20 seconds if no motion is detected.

【EASY TO INSTALL】: This motion sensor led lights is easy to install. You just need to suck the tape with the supplied magnet on the light, then tear off the tape and stick it where you need it. No tools, screws or nuts needed. You can stick it to any flat surface, it's that simple, and you can remove it from the magnetic strip when you need to.

The lamp 3 color in 1 lamp

Short press the first, the lamp will be on, and the lighting color is cool white. The mode is induction, and in this mode long press about 2s,the lamp will flash twice, then will be into always on mode, the lighting color will not change. Short press again, the lamp will turn off.
When the lamp is in the induction mode, short press the switch, the lamp will change the lighting color.

High brightness LED chip, eye protection and no flicker

How to handle the lamp:

Press the switch for the first time: always on mode;
Press the switch for the second time: night sensing mode;
Press the switch for the third time: all day sensing mode;
Press the switch for the fourth time: OFF;
Press the switch all the time: adjust the brightness